68camaro

Check this out, for you that have not seen it.... http://video.kenblockracing.com/flash/small_player/preloader.swf?vendor_id=204&media_id=9183&bgcolor=FFFFFF&autoplay=0

Look in the reservoir and see if it is dirty. If it is the heater core is plugged up.

that is right......

Went to the ADRL meet in Norwalk, it was a blast. They had alot of cars in each class trying to qualify for 16 spots.

Best way is to make sure the park switch is working correctly, then with the wiper arms are off the transmission, run the wipers then shut them off with the wiper switch. Not the ignition switch. Let them park then install the wiper arms to the transmission which is the pivots that comes through the body. Sounds to me the park switch might be bad.

Some of the newer Camaros mount the front turn signal socket upside down. As in the bulb hangs down from the socket. Then the heat from the bulb melts the plastic socket causing problems. I have replaced a few of the front sockets on the newer Camaros.

How can you run both fans in series when the 1st fan is grounded all the time? To run both fans in series then change to parallel you would need dpdt relays....

Here are the current specs....400 small block standard bore, 11 to 1's. World heads with 2.08, 1.60 valves. 640 lift roller cam. Forget the rest specs on cam. Professional Products intake. 750 Holley on a 2 inch spacer. Have 175 hp nitrous plate system but have not used it on this engine combo yet....350 trans with Transking transbrake. 9 inch Transking convertor. Stalls around 4200. Leaf springs with ladder bars. Moroso front springs. Competition Engineering 90/10 shocks front. Stock shocks moved inward to clear tires. Moroso front tires. Mickey Thompson 29.5 X 10.5 slicks. Dynomax round racing mufflers. 4.88 gear with a spool. Henry's axles with c clip eliminators.

Gearhead is right, I have wired up a few racecars that way....always works.....also as in NHRA rules, car has to shut off when switch is moved to "off"

ok....found it...thanks..

Is there anywhere to buy vinyl cutter supplies in Columbus? I have been buying the supplies on the net. Would like to find them local if I could.

Thanks, have not had it out yet this year due to breaking the differential and bending the housing the end of last year. Hope to have it finished in a couple of weeks. Should run a little better. Going from a 4.10 to 4.88......

here it is.....best et last year was 10.81 http://i19.photobucket.com/albums/b165/thomas1977/camaro22.jpg

Hi all, another new 1 from Wash.C.H.