Jump to content

Sprocket ratio change?


imagineer

Recommended Posts

Anyone change their sprocket ratio to make their sport bike a little more touring friendly?    I'm thinking of swapping the stock 15/45 sprockets on the Bandit for a new chain and a smaller rear sprocket (and maybe a larger primary) to make the bike buzz less when at highway speeds.    

 

I recently made an 80 mile errand run on the highway and although being able to accelerate from 60 to 80 in a blink of an eye is nice, I'm wondering of a more touring friendly ratio would suit my riding style.   It might also help me stop trying to find 6th gear (that doesn't exist).

 

Any thoughts?

Link to comment
Share on other sites

Easily doable.  However, gearing is only one of the issues with trying to use a sport bike as a tourer, tho.  Seat comfort, cramped riding position, and wind protection are all a compromise.  Only real issue with re-gearing is that most modern bikes drive the speedo off the transmission, so your speedometer will be inaccurate (if you gear down, indicated MPH will be lower than actual MPH) by whatever percentage you change the final ratio, i.e., going from a 15/45 (r=0.333) to a 16/44 (r=0.3636) results in a about 9% overdrive.  Prolly not QUITE as bad as it sounds because a typical factory speedo calibration is usually about 2-3% high.

 

To add to the above, you need to keep the total number of teeth on the final drive pretty close to the stock number of teeth or you'll need to cut or add chain links to alter the length. +/- one or two teeth shouldn't be a problem, but three or more is not likely to work without mods.

Edited by Bubba
Link to comment
Share on other sites

The bandit is already geared quite long and most 1200 riders suggest against adding a tooth up front as it makes much more of an impact than dropping a couple out back. Mine has stock gearing and turns 4k rpm at 70 mph. That's really not bad.

Link to comment
Share on other sites

One of my bikes has a 17tooth front instead of the 16 stock. I find it doggy off the start. And increased vibration on the road. It changed to road ratio, but pushed 6th gear cruise rpm down into a vibration range. Will change it back. A stock Honda front sprocket has a rubber dampener to kill vibration. Aftermarket sprockets will not have that.

Link to comment
Share on other sites

Both my bikes are +1 in front. I like the lower revs. Niether of them are noticeably slower either as I can hold a lower gear longer. Initially I went -1 in front on the cbr which was cheap entertainment but sort of pointless.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...