Jump to content

5.0 fox rocker arm question


Dave1647545494

Recommended Posts

i had to clearance the baffle with my ford motorsports 1.6 roller rockers on a stock rocker cover. put some clay on the baffle, screw the rocker cover down without a gasket, and turn the motor over a few times--you'll see just how close it comes. as long as it doesn't come into contact, the cork gasket should give you a little more clearance
Link to comment
Share on other sites

To my knowledge T&D only makes shaft rockers set-ups. I had to grind clearence in a set of ford motorsports cast aluminum tall valve covers where the outer two bolts were to clear the stands.

 

Be careful and inspect the pushrod hole threw valve lift travel. I had to slot my pushrods holes because of where the T&D's relocated the pushrod seat.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...