Science Abuse Posted March 25, 2009 Report Share Posted March 25, 2009 Never pulled one before, thought it'd be smart to ask for tips before I got started. Looks like getting the snap ring out is easy enough, but what happens next? I'm putting in an aluminum driveshaft, and need to keep the TKO yoke. Thanks. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted March 25, 2009 Report Share Posted March 25, 2009 ball joint press doubles as a u joint press. i would say hammer them out, but i hate doing that to aluminum Quote Link to comment Share on other sites More sharing options...
Science Abuse Posted March 25, 2009 Author Report Share Posted March 25, 2009 ball joint press doubles as a u joint press. i would say hammer them out, but i hate doing that to aluminum Actually just did that to the old one that was in the AL shaft, had no issue. Will be careful lining it up on the way in. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted March 25, 2009 Report Share Posted March 25, 2009 junk sockets come in handy when using the bfh.. can even use the vise too...to help press them into place Quote Link to comment Share on other sites More sharing options...
Science Abuse Posted March 26, 2009 Author Report Share Posted March 26, 2009 U joint: too cheap not to replace, or resilient enough that it's not worth the run to the store...? Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted March 26, 2009 Report Share Posted March 26, 2009 cheap insurance Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.