jeffro Posted June 11, 2010 Report Share Posted June 11, 2010 the previous owner installed an alarm system on the integra. it has 2 key fobs, and everything worked. he then replaced the ignition switch and now the alarm/keyfobs dont work. does anyone have a wiring diagram that could assist me in hooking them back up? i mostly just want the keyfob to work again. Vehicle: 1994 Integra LS. Quote Link to comment Share on other sites More sharing options...
Igor Posted June 11, 2010 Report Share Posted June 11, 2010 Here you go. http://i46.tinypic.com/1676y3p.jpg On a separate page i didn't feel like uploading. NOTE * 1 these wires are in the LARGER of the (2) GRAY Plugs, in the LOWER DRIVERS KICK near the FIREWALL. If vehicle is equipped with a CRUISE CONTROL, these plugs are BEHIND this MODULE. You must remove this module to access these plugs. Wires will only test with the PASSENGER DOOR LOCK SWITCH. NOTE *2 this wire is in the LARGER of the (2) GRAY Plugs, in the LOWER DRIVERS KICK near the FIREWALL. If vehicle is equipped with a CRUISE CONTROL, these plugs are behind this module. You must remove this module to access these plugs. NOTE *3 this BLUE tach wire is also located in a 16-Pin WHITE or GRAY Plug to the LEFT of the FUSEBOX. Quote Link to comment Share on other sites More sharing options...
jeffro Posted June 11, 2010 Author Report Share Posted June 11, 2010 just got under the dash, its a python 460hp. doing some research Quote Link to comment Share on other sites More sharing options...
jeffro Posted June 11, 2010 Author Report Share Posted June 11, 2010 FUUUUUUUUUUUUUUUUU. who can get this wired up properly and for how much? Quote Link to comment Share on other sites More sharing options...
Igor Posted June 11, 2010 Report Share Posted June 11, 2010 Its not hard. I'm willing to help if you want. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.