BlackMess Posted July 23, 2010 Report Share Posted July 23, 2010 I installed a 10" pusher fan on my condensor and have a wiring question for the wiring gurus on the forum! I have the fan wired up through the stock A/C relay that is controlled by the mazda interlock switch. When I probed it out with my test light prior to pinning the wire and when I had the switch pressed I had light(12v.) and durng the release I did not. So I wire the fan up and press the switch and it works, release the switch and the fan stays on. I have to remove the key from the ignition in order to turn the fan off. If I start the car without the switch pressed in no fan. Can I add some sort of bleeder resistor so the fan will shut off when I release the switch. The fan is 7.0 amps, I'm using 10ga. wire with a good ground. Any ideas??? Quote Link to comment Share on other sites More sharing options...
Dave1647545494 Posted July 23, 2010 Report Share Posted July 23, 2010 what year is your car so I can have a look at the A/c wiring diagram on mitchell Quote Link to comment Share on other sites More sharing options...
BlackMess Posted July 24, 2010 Author Report Share Posted July 24, 2010 I had no luck so with the stock mazda wiring so I wired it in parallel with the GM a/c compressor. Thanks for the offer! Quote Link to comment Share on other sites More sharing options...
Dave1647545494 Posted July 24, 2010 Report Share Posted July 24, 2010 ok long as it works now Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.