Jump to content

FS: 2 12" Polk Momo Subs & Alpine Amp


Fubar231

Recommended Posts

Up for sale are 2 12" Polk Momo subwoofers in a sealed box. I don't know the model number of the sub (Could pull the subs out and check), but i know these things SLAMMM. Also for sale is a Alpine Amp 1000 watt 2 channel but it will not power on, It was fixed before for $100 and worked fine for a few months, then had the same problem.

 

Would like $200 for the subwoofers / box (OBO)

 

Would like $200 For the amp (OBO)

 

Or $350 OBO for it all

 

Pics:

http://i50.photobucket.com/albums/f302/SevereSarz/IMG00338-20100805-2251.jpg

 

http://i50.photobucket.com/albums/f302/SevereSarz/IMG00339-20100805-2252.jpg

 

http://i50.photobucket.com/albums/f302/SevereSarz/IMG00341-20100805-2253.jpg

 

 

This system SLAMMED HARD when it was in my friends WRX and worked. I am willing to seperate the Sub and Amp of course, but not willing to seperate subs individually etc.

 

Thanks,

Shane

 

 

 

AMP Specs

Price & Contact: $730 USA;

All measurements @ 14 volts unless otherwise specified.

Frequency Response (4 Ohm IHF Load 20Hz to 20 kHz, 1 kHz Ref.): +0 dB, -0.2 dB

L/R channel error, max deviation 20 Hz to 20 kHz: 0.2 dB

Phase Response (4-ohm IHF Load 20Hz to 20kHz 1kHz Ref.): +6.5 degrees, -12.3 degrees

Signal-to-Noise Ratio (Below Rated Output, “A” weighted): -118.2 dB

Distortion at Rated Output @ 1 kHz: 0.25% @ 900 watts

Output Power(resistive) minimum output 20 Hz to 20 kHz @ 1%THD+N (all channels driven into 4 ohms): 274 watts x 2 @ 14 volts; 225 watts x 2 @ 12.8 volts; 140 watts x 2 @ 10.5 volts

Output Power (resistive) minimum output 20 Hz to 20 kHz @ 1%THD+N (all channels driven into 2 ohms): 455 watts x 2 @ 14 volts 371 watts x 2 @ 12.8 volts; 227 watts x 2 @ 10.5 volts

Output Power (4-ohm IHF Reactive Load @ 60 Hz to 1% THD+N): 995 watts

Crosstalk (Referenced to Rated Output, 20 Hz to 20 kHz): -52 dB

Damping Factor @ 100 Hz, 2 ohms: 348

Voltage for Rated Output: 215mV to 4.5 volts

Idle Current Draw: 1.5 amps

Current Draw @ 1/3 Maximum Power: 63.5 amps @ 316 watts

Efficiency @ 1/3 Maximum Power: 36%

Power-Up Noise: -3.7 dB SPL

Power-Down Noise: 22 dB SPL

Edited by Fubar231
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...