On3Performance Posted May 24, 2012 Report Share Posted May 24, 2012 Dont care if it works or not but just need to use it to make a drawling of the one fitting on it Thanks Link to comment Share on other sites More sharing options...
Flybye Posted May 24, 2012 Report Share Posted May 24, 2012 I have one and will be off polaris tomorrow. Not sure if it is off of a mustang or truck though? Link to comment Share on other sites More sharing options...
CbusBusa Posted May 24, 2012 Report Share Posted May 24, 2012 I'm actively looking for a working one and you can have my old one when I get the new one put on. Link to comment Share on other sites More sharing options...
On3Performance Posted May 24, 2012 Author Report Share Posted May 24, 2012 that would be good Im sure either way. There is a small and large threaded port on them and Im just trying to get a drawling for that o-ring thread male fitting that is on the compressor. Can you verify if yours has that flybye? If so how much? RT, if that above one doesnt pan out, just let me know when you pull that. If I get the one above and its a mustang unit, I just need it a few days for the machinist to see it and your more than welcome to it. I just need it a few days Link to comment Share on other sites More sharing options...
CbusBusa Posted June 4, 2012 Report Share Posted June 4, 2012 I replaced mine and have the old one sitting in the garage if you still need it Link to comment Share on other sites More sharing options...
Recommended Posts