Jump to content

Kz1000 throttle cable


Ocyrus

Recommended Posts

I bought two throttle cables for my '77 KZ1000B. For some reason it seems about an inch too short on one end once I hook the other end up. I tried to adjust it out as far as it will go but it's not enough. The Pony says that is the only one they show for my bike. Any suggestions?

Link to comment
Share on other sites

Check the length against the one you took off. If they are the same, the routing isn't right. Common problem, happens a lot. There should be a description or diagram in the service manual.

Link to comment
Share on other sites

The Bars are not stock. I have drag bars so the cables do not feed thru the bars. The routing is correct and simple. I can get the cable to rest in the holder/guide but when I pull the wire itself, the little ball at the end will not quite reach in the hole to operate the carb.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...