Jump to content

Window Repair Contractor!


redkow97

Recommended Posts

Any recommendations for a contractor in the Cleveland area who can replace a window?

My neighbor's glass-block window literally fell out of its frame yesterday. The window itself is still intact, but the frame is completely rotted.

I boarded up the window for her, but she doesn't know who to call, and my concern is that a basic window company isn't going to know how to properly fix the frame.

Advice?

Link to comment
Share on other sites

I worked at cincinnati glass block a few years ago.  

 

go to home depot they sell glass block. any idiot can do this if you have general construction knowledge.   they sell the mortar too.  most glass block companies use silicone instead of mortar now.  not sure if home depot sellsyjr proper silicone for this  or not.  they should.  you want clear.

measure the opening and bring it with you.  bring a tape measure.  the blocks come in a few different sizes.   sometimes you have to go with a few of one size and one of another to get as close as possible.    to assemble the blocks lay them down on a flat surface and glue them together.   silicone is so much easier for this job.  let it set up for a day or two.  and it's ready to install. if you use mortar that's a big time mess and undertaking because you have to space the blocks etc to get a even look.  you basically do it just like a brick wall. 

 

they also of course sell the mortar that goes around the window.   it's not the same as the mortar you assemble the glass block with.   buy a foam brush too.   you will need to mix it with water and you can use whatever you want to fill the opening with.  I often just used my hands.

 

pad the window up at the bottom with cedar shims.  you want the window centered in the opening for the best apperance.  now use the other shims to hold the window tight in the opening.  cut the shims back with a razor blade as flush as you can.  now you can pack the gap with the mortar.  they also have a bag like a cake maker uses for icing.  they come in handy but not really needed for just one job.  after you pack the sides, top and bottom scrape it flat with a trowel etc.  then dip your brush in water and use it to finish the mortar.

 

if you lived in cincy I'd do it for about $80 not including the materials.  you'll end up paying about $200 I would guess for a glass block company to do it.

Edited by serpentracer
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...