o-no-moto Posted March 24, 2015 Report Share Posted March 24, 2015 So I need a little help with my nephews 02 kx 60. Long story short stator coil,cdi,and ignition coil have been replaced. I have two wires coming from the stator. Blk/red and blk/white. I can grab both wires and kick the motor over and get a decent bite on my fingers. These two wires go directly to the cdi. Cleaned all the ground connections. Check the resistance on the stator coil and is 290 ohms spec is 460-580. My question is there a generic ac voltage the stator should put out to the cdi and if the cdi is getting voltage shouldn't I get a reading from the cdi to the coil. If so I ain't getting anything. Quote Link to comment Share on other sites More sharing options...
Gixxus Christ! Posted March 24, 2015 Report Share Posted March 24, 2015 Found this:http://www.thumpertalk.com/topic/567728-kx65-stator-testing/Very good trouble shooting info. Quote Link to comment Share on other sites More sharing options...
o-no-moto Posted March 25, 2015 Author Report Share Posted March 25, 2015 Thanks for the info Sam. I found the problem from my old repair.just the thinist piece of wire poked through the shrink tube. Quote Link to comment Share on other sites More sharing options...
o-no-moto Posted March 25, 2015 Author Report Share Posted March 25, 2015 . Quote Link to comment Share on other sites More sharing options...
o-no-moto Posted March 25, 2015 Author Report Share Posted March 25, 2015 Stupid phone...try ing post a pic Quote Link to comment Share on other sites More sharing options...
o-no-moto Posted March 26, 2015 Author Report Share Posted March 26, 2015 . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.