Jump to content

Electronic Boost Controller Install ?'s


Fubar231

Recommended Posts

I have a question about the EBC im about to be installing here on saturday. Reading the installation manual it says T the 4mm vac line off the FPR Vacume Line and run it to the EBC (For the built in , but needed , boost gauge).

 

http://i50.photobucket.com/albums/f302/SevereSarz/asdfaas.jpg

 

My question is, can i just tee it off somewhere else thats close? I'd rather not cut up my FPR vac line, and just T it off a intake manifold line that im already using for my boost gauge.

 

Is the FPR vac line going to be more precise/responsive than another vacume line?

 

Ill go grab a picture of where i have my boost gauge tee'd in and you guys can judge for yourself.

 

I have my boost gauge tee'd in off of my turbo pressure sensor vac line.

 

http://i50.photobucket.com/albums/f302/SevereSarz/IMG00005-20091224-1655.jpg

Link to comment
Share on other sites

Got a response off the supraforums.

 

Guy said as long as its a boost source it will be fine, but keep in mind weather its tee'd in before or after the intercooler with effect the readout due to pressure loss. Im trying to find out where the vac line from my turbo pressure sensor goes, cause im most likely just going to tee it off there.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...