BlackMess Posted March 12, 2010 Report Share Posted March 12, 2010 I was cleaning up the engine bay in the FD and bumped the abs pump. I noticed a VERY small leak on the inlet on the FR and FL lines,the rear is fine. I replaced the copper washers and it was still leaking around the upper and lower copper washer. WTF this is driving me nuts?? Am I thinking about this to hard? To tight? To loose? Bad crush washers? I'd imagine torque spec woulnd't be more than 14-20 ft/lb. The new washers seem to have a round side and flat. Flat down? up? does it matter? update.. I heated the washers up with a torch, let them cool and was able to get one line to seat. The other washer wont compress at all. The top seated but the bottom is leaking BARELY. Quote Link to comment Share on other sites More sharing options...
Dave1647545494 Posted March 12, 2010 Report Share Posted March 12, 2010 try a different washer that will compress a little Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.