Jump to content

2006 Saturn ION Redline - Official build thread


10_penn
 Share

Recommended Posts

2006 Saturn ION Redline - 72000 miles

Stock motor rated at 205hp/200tq (2.0L supercharged Ecotec LSJ 4-cylinder)

 

Engine

  • Block
    • ZZPerformance reinforced LE5 block (from 2.4L Ecotec LE5 - 88mm/3.465” bore)
    • Stock LSJ crankshaft (86mm/3.386" stroke)
    • Eagle 4340 forged steel rods/ARP 2000 bolts (for 2.2 Ecotec L61 - 146mm/5.765" center-to-center length)
    • Diamond pistons - custom order (10.5:1 CR)
    • Total Seal Gapless rings
    • Level Zero Performance balance shaft delete kit
    • ATI Superdamper
    • Ecotec LSJ oilpan
    • New GM OEM thermostat, gears, gaskets, water pump, bearings, chains, chain guides, bolts, seals where applicable

     

    [*]Head

    • Ported/polished intake/exhaust ports
    • Stock valves with 3-angle valve job
    • ZZPerformance Stage 2 supercharged cams
    • ZZPerformance 82# valve springs
    • ARP headstuds
    • Ecotec LNF piston oil squirters
    • New GM OEM lifters, followers, valve guides, LE5 headgasket, bolts, bearings, gaskets where applicable

     

    [*]Power Adder

    • Harrop HTV 1320 LSJ - Eaton TVS 1320 series rotors
    • 2.7" Supercharger pulley
    • Air-to-water single-pass intercooler system, electric water pump, added aftermarket flow-through tank

     

    [*]Exhaust

    • ZZPerformance Longtube, equal-length header
    • ZZPerformance 3" downpipe w/Magnaflow high-flow cat, Magnaflow resonator
    • ZZPerformance 3" cat-back exhaust w/Magnaflow muffler
    • AEM UEGO Wideband

     

    [*]Fuel System

    • Stock fuel pump
    • ZZPerformance Boost-Referenced Fuel Pressure System
    • Stock fuel lines
    • Injector Dynamics ID1000 - 1000cc fuel injectors
    • E85

 

Drivetrain

  • Stock GM OEM transmission, 4.05 final drive, F35 MU3 Getrag
  • Redline MT-90 Manual transmission fluid
  • NAPA revised axles - 1mm larger diameter, heat treated
  • GM revised shifter bracket
  • GMPP LSJ Clutch upgrade kit

 

Suspension

  • Powell Race Shop rotated anti-wheel hop transmission mounts
  • Ingall’s Engine Torque Dampener
  • Powergrid Inc. Sway bar end links
  • Coppertop twin-bar subframe brace
  • Jason Smith upper strut brace
  • Centric cross-drilled/slotted rotors with Hawk HPS pads
  • Dunlop Direzza Sport Z1 Star Spec tires (245/45/R17)

 

Interior

  • AeroForce dual interceptor scan gauges
  • AEM UEGO Wideband
  • AEM Fuel Pressure gauge
  • B&M short throw shifter w/base bushings
  • nyrm98 Dual A-pillar and Dual Steering Column gauge pods
  • Recaro seats (factory)
  • Battery in trunk (factory)

 

Exterior

  • OEM Competition Package gunmetal wheels
  • Rear Aero-Spoiler delete
  • Debadged
  • 6k HID headlight conversion
  • Tinted front corners/tail lights with "REDLINE" decal over 3rd brake light
  • Polished valve cover
  • Red painted spark plug cover, strut brace, brake calipers

 

Tuning

  • HP Tuners
  • All tuning done by myself

 

Final displacement of the motor will be 2.1L, and the car is expected to see 8,000 rpms and 23 psi of boost. Since this is a different build than the majority of Ecotec LSJ owners, the total power rating is unknown but expected to be around 440-450 whp, 350-370 wtq. The a/c is still in the car, as is the full interior and spare tire. Motor is almost complete, waiting on the head to return from the machine shop, then it's just assembly.

 

http://i20.photobucket.com/albums/b224/azn_ladie82/cars2/15.jpg

 

Debadged, dewinged, and tinted tails

http://i20.photobucket.com/albums/b224/azn_ladie82/cars2/mms_picture64.jpg

 

Shortblock complete

http://i20.photobucket.com/albums/b224/azn_ladie82/2006/Engine%20Build/1335118224005.jpg

 

TVS 1320 (1.32L - top) vs stock M62 (1.0L - bottom)

http://i20.photobucket.com/albums/b224/azn_ladie82/cars2/DSC04791.jpg

Link to comment
Share on other sites

Other than the front fascia, car looks clean.

Only thing you need now is the RWD conversion. ;)

 

What are you hoping to squeak out of her?

13's 12's?

 

There's a guy with a Cobalt SS/SC that went 12.007 @ 118 on slicks on 70 fewer hp than what I am expecting. I'm hoping to break that and get in the mid-high 11's. :)

 

I know it's not got the prettiest face, but it's stock body kit, and it was 18k brand new... Hard to say no to that cheap price.

 

And man, I wish it was RWD/AWD...

Link to comment
Share on other sites

In all honesty, the gauge cluster is perfectly fine. It takes about a day to get used to it, and then you don't ever even notice that it's not in the traditional location. People made too big of a deal out of it. I actually kind of prefer it in the center now. The reviews were not good for the ION because the gauges were "awkwardly placed," but yet in the Toyota Yaris, it was "cool and quirky."
Link to comment
Share on other sites

In all honesty, the gauge cluster is perfectly fine. It takes about a day to get used to it, and then you don't ever even notice that it's not in the traditional location. People made too big of a deal out of it. I actually kind of prefer it in the center now. The reviews were not good for the ION because the gauges were "awkwardly placed," but yet in the Toyota Yaris, it was "cool and quirky."

 

Don't worry, we think you are cool and quirky too!

Link to comment
Share on other sites

Don't worry, we think you are cool and quirky too!

 

Lol thanks...:masturboy:

 

Cool build, my buddy on here has a Blue Ion, turbo... Makes some nice numbers.

 

Think I might remember that one.

 

Zzpperformance turbo kit lots of extras 407 whp 445 wtq

 

Yep.. I thought about that route, but I could reach my goals staying supercharged. Any more than 400-450 whp in a FWD car is pointless anyway unless you're running DR's all the time.

Link to comment
Share on other sites

I have a good set of summer tires on it, those mentioned above, but with this much power on a fwd car, I'm probably not going anywhere without a set of street-legal DR's for weekend nights and track days. Not sure what brand yet tho.
Link to comment
Share on other sites

Neat build, car looks much more mature.

 

Thanks man.

 

Jones, let the dead car company car owners fight amongst themselves.

 

 

Srs, sounds like a very cool build.

 

Thanks, that was actually very funny.

 

Haha. If I can use it. I'll take it. Just let me know.

 

I'll throw together a list at some point and let you know.

Link to comment
Share on other sites

http://i20.photobucket.com/albums/b224/azn_ladie82/2012-06-01_21-01-40_253.jpg

 

http://i20.photobucket.com/albums/b224/azn_ladie82/2012-06-01_21-01-48_287.jpg

 

http://i20.photobucket.com/albums/b224/azn_ladie82/2012-06-01_21-02-01_538.jpg

 

Moving right along....

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...