Jeepman3ski Posted August 4, 2010 Report Share Posted August 4, 2010 I finally got around to installing my clear alternative integrated tail light yesterday. It took me about an hour start to finish with everything and figuring out a way to mount the license plate. Anyways, its all installed. However now my engine check light is on. The bike runs fine. I wired the bike the following way:Plugged the main tail light connector in (yes that was very tough). Figured out what wire from the signals actual ran the tail light. There were two wires on each (of course). I capped the wire that I didn't use. Should I have grounded it or done something else with it? That is the only thing I could have seen that I have done wrong. Any advise would be great. I did not install the resistors as this is optional and I like the fast flash turn signals. Quote Link to comment Share on other sites More sharing options...
gen3flygirl Posted August 4, 2010 Report Share Posted August 4, 2010 PM cheech, I am pretty sure he is good with electrical stuff and is in the area. Quote Link to comment Share on other sites More sharing options...
Jeepman3ski Posted August 6, 2010 Author Report Share Posted August 6, 2010 Well after talking to a few triumph people. The bike needs to be run 3 times for the computer to run through all of its "stuff' I'm not sure how much I believe that BUT the 4th time I rode it being today the light was off. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.