Jump to content

Kawasaki vulcan 88 1996 help/


gl1200

Recommended Posts

trying to help a friend , He was riding on I-71 , bike just acted like it was running out of gas , started to slow down ,then came back , done this a couple times , almost full tank of gas . finally just quit and lost all electrical even neutral lite. got it haulled home charged battery , still nothing , but if he jumps across the solenoid the motor will crank over .

anyone know where to start ?

Thanks

Link to comment
Share on other sites

It's an electrical problem, put the hammer away.

It actually sounds like a short circuit somewhere. Pull one fuse at a time, and turn the key on, to see if the fault circuit can be identified. Then try disconnecting items on the electrical harness. Like the radiator fan or horn. Things that like to short out.

Overall, start looking for bad wiring somewhere. Pinched or broken or shorted to ground. Another trick is to turn the key on, and start shaking wires everywhere, to see if the neutral light comes on. Or even listen real close, since it might be a short that will pop/click when it arcs to ground.

My first guess is a bad ignition switch. Try shaking the key in the ignition to see if the neutral light comes on.

It's also likely that it's shorted only when the key is on. (Since the battery isn't dead already.) Only a VOM meter and tracing the circuit will know for sure, but sometimes just basic troubleshooting will find it.

Link to comment
Share on other sites

I've had radiator fans, tail/brake lights, and points assemblies short out and shut the bike down. It happens. Another thing to check. Look at the fuses real close, one or more of them might now be blown out. (Since there's nothing now.)

Link to comment
Share on other sites

Wow, hard to say. In the first part, I started thinking pinched fuel line from not being careful lowering the tank after service. Now we're talking electrical. The battery is only used to start the bike. After that, the generator takes over all the electrical demands. After all this time the brushes may be worn in the generator and it's not charging so you're running on battery until it gives out. If the battery is bad it won't hold a charge. Generally, if you fully charge it and the voltage drops below 12.6 or 7 overnight all on it's own without any drain on it, then it's time for a fresh one.

The battery is the easiest thing to test first. It really sounds like you need to check any wiring that could be chaffed. Could be an ignition switch, too. Again, wiring related. Try fiddling with the key while you're trying to start it, and if you do get it running, check voltage at the battery to see how the generator's putting out. I keep going to ignition switch. That or kickstand switch. GL!

Link to comment
Share on other sites

It's an electrical problem, put the hammer away.

It actually sounds like a short circuit somewhere. Pull one fuse at a time, and turn the key on, to see if the fault circuit can be identified. Then try disconnecting items on the electrical harness. Like the radiator fan or horn. Things that like to short out.

Overall, start looking for bad wiring somewhere. Pinched or broken or shorted to ground. Another trick is to turn the key on, and start shaking wires everywhere, to see if the neutral light comes on. Or even listen real close, since it might be a short that will pop/click when it arcs to ground.

My first guess is a bad ignition switch. Try shaking the key in the ignition to see if the neutral light comes on.

It's also likely that it's shorted only when the key is on. (Since the battery isn't dead already.) Only a VOM meter and tracing the circuit will know for sure, but sometimes just basic troubleshooting will find it.

He did say thet the brake ligth fuse was blown and they replaced it , I don't know if they double checked it after turning the switch back on ??

Link to comment
Share on other sites

He did say thet the brake ligth fuse was blown and they replaced it , I don't know if they double checked it after turning the switch back on ??

That's a clue. Unplug the brake light and stuff on the back, and see if it starts and runs ok. If it's true, then find the wiring problem in the back end and fix it.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...