Twistedrx7

You poop in a sac and throw it down the tub. Just gotta make sure someone isnt using the tub. I have to put that out yet. The vent is located in the inlay about a foot from the tub. and the pooper hole is right where that ugly tile is with the brown stain. In order to make the cut out easier i can get to the tile from the bottom side and draw it from there then cut it out. Thinking of slicing the tile in two and cutting it from there. Or drilling holes all the way around it so its one tile.

Just have to cut a little off the left side outside border to get it fit (walls runs out an inch). And then cut in the rest of the inlay, then mortar. http://i27.photobucket.com/albums/c168/twistedrx7/Mobile%20Uploads/1121002107_0001-1.jpg

I would go with the GM sensor(open element) rather than the Rotary sensor (AIT). You can do that or shave down your sensor so the reaction time is faster. The two places you can mount the new AIT is right after the IC or in the elbow. You will not heat soak it as much in either place. Yes, your PFC will read the correct temp much better after relocating it. If you notice it takes a while for the temp to change on it. There is nothing wrong with using the gm 3 bar just as long as you have that selected in the PFC setting. Hopefully you have a datalogit, if not it isnt too hard to change with the controller.

whhhat?

thanks guys Sam is helping me out on this one!

I would rent however the time im going to need it and the price of the rental will be about the same if i bought one.

I am looking for a wet saw to finish up some tile work. So if you know where i can get one for a reasonable price, or if you have one i could borrow and i can throw some money your way let me know. Thanks

looks worse than the veilside that was on mine

HOLY CRAP!

who has used Ditra here and what thinset brand did you have the best result with? This is going being bonded from the plywood to the ditra. Ive seen Versabond, 317/333, 252, 254. what do you use and why?

hit or miss with retagit

im going pass for now

clay you know we dont have to stay outside

suck it up

last time it was there was 070707. i dont think pinapple sells their own lim it is the GZ LIM. you can run 2 or 4 injectors. So if you want to upgrade later with the CJ the option is there whereas with KG its not.

HAHAAH

would have gone with the new CJ setup IMO. allows for 4 injectors on the secondary and also has room for the GZ LIM. who did the rebuild? Also all those Vacuum nips you have the LIM, are not needed. they go straight through. You can pull them out with pliers. They were there to make it easier to get to the Rats nest.

why -6an lines? why not do -8an since the stock ones are just about -6an. I would make sure you have a nice system where if one pump goes out the whole system shuts down. Otherwise you risk going lean. You can say you have an AF and fuel pressure reg but by the time you see it, it is already too late

didnt see this weather you speak of.

might actually show up to this one, also i really do want a tuna melt bagel from blocks

pretty interested. will let you know soon

think there will be a lot of people killing themselves and giving props to the book for it?

What makes this worth more than asking price for say a stock one in the same condition, aside from the things customized for you? (serious question)

i admit i LOL

This just went from fun, to serious...