Jump to content

Wiring help-Camaro


Guest FooFooMaru

Recommended Posts

Guest FooFooMaru

I have a '94 camaro. while ago my car alarm ( Code Alarm Pro 300 ) went retarded and ended up cutting it out. Welp basically i wanted to either hook it up again and see if anything was wrong before (it would go off and not turn off) that and to get the lock/unlock and such stuff to work again

 

Any help is appreciated so wire guys please help.

 

Thank You

 

Dane

Link to comment
Share on other sites

Did you cut the wires out or did you remove them totally? If you just cut them match all the colors back up. When I have reinstalled system I could use the colored wires to do it.

 

12 VOLT CONSTANT RED (+) IGNITION SWITCH HARNESS

STARTER YELLOW (+) IGNITION SWITCH HARNESS

STARTER 2 N/A

IGNITION 1 PINK (+) IGNITION SWITCH HARNESS

IGNITION 2 N/A

IGNITION 3 N/A

ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS

ACCESSORY/HEATER BLOWER 2 N/A

KEYSENSE N/A

PARKING LIGHTS ( - ) N/A

PARKING LIGHTS ( + ) BROWN (+) IN DRIVERS KICK PANEL, HARNESS heading to REAR of Vehicle

POWER LOCK LIGHT BLUE See NOTE *1

POWER UNLOCK DARK BLUE See NOTE *1

LOCK MOTOR WIRE GRAY (+) IN DRIVERS DOOR HARNESS

DOOR TRIGGER GRAY (-) BEHIND LEFT REAR SPEAKER

DOMELIGHT SUPERVISION USE DOOR TRIGGER, Requires #775 Relay

TRUNK RELEASE BLACK/WHITE (+), Requires #775 Relay LOW in PASSENGERS KICK PANEL

SLIDING POWER DOOR N/A

HORN BLACK (-) @ BLACK Connector in Steering column harness

TACH WHITE or RED/BLACK @ COIL PACK See NOTE *2

WAIT TO START LIGHT N/A

BRAKE LIGHT BLUE (+) or YELLOW (+) @ SWITCH ABOVE BRAKE PEDAL

FACTORY ALARM DISARM N/A

ANTI-THEFT 2 WHITE or 1 WHITE and 1 PURPLE, wires are in an ORANGE tube GM's VATS System @ Ignition Switch

Link to comment
Share on other sites

I had a webpage that I went to that explained with pictures and whatnot exactly how to hook up an alarm including wiring diagrams etc.... I'll try to find it.... I think it was on the projectta website
Link to comment
Share on other sites

Guest FooFooMaru
I cut two wires. The techs at a local shop (good guys) took the car alarm out so i'm not sure what happened with that unstalling? Only one wire connected to the Code Alarm Pro 300
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...