Guest 5.7 Posted July 31, 2007 Report Share Posted July 31, 2007 Pulled the dash on a car to remove the HVAC, then reinstalled. Went to turn the engine and it will not turn over. Tried using the old screwdriver across the terminals and it will fire but die right after it fires. Any ideas what the problem can be? It looks like I have all the wires plugged back in under the dash, but you just never know. Code P1626 is "theft deterrent fuel enable signal" The pump primes with every cycle if that helps any Quote Link to comment Share on other sites More sharing options...
Clifford Automotive Posted July 31, 2007 Report Share Posted July 31, 2007 Check connection under steering column to key lock cylinder Prove wiring is good from key lock cylinder to connector under steering column (use a meter) The TDR can sometimes be at fault. It is located to the right of the glove box, next to the hatch relay. It is pinned to the metal structure of the dashboard. It is easiest to see if you poke your head under the dashboard and look back toward the rear (after removing the lower dash panel). Quote Link to comment Share on other sites More sharing options...
Guest chpmnsws6 Posted July 31, 2007 Report Share Posted July 31, 2007 When you turn the key to the "start" position, the lights on the dash all go out like normal. That is the only thing that is throwing me for a loop. Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted July 31, 2007 Report Share Posted July 31, 2007 Here is all the info you need... http://gearchatter.com/viewtopic8961.php?sid=ca8245ee2f5d06b3e4c2431703da4216 Check your fuses... Also try cleaning the chip in the key with alcohol if all else fails. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.