Diamonds Posted April 1, 2009 Report Share Posted April 1, 2009 Below are the major parts that I have on the bike. Nothing is stock. The bike is set up for MX type riding with main emphasis on low and mid range power but will still top out around 110mph. Bike is setup for a 200-225 lb. rider. Motor still needs broken in… Any questions, call me 740-310-1284. i spent over 12k building it. $6,000 firm plus buyer gets approximately $1,000 in stock parts. Tell your friends. PARTS: Tag T2 fat bars Fat bar mounts IMS shifter Lonestar park brake block-off Clutch perch Shorty clutch & brake lever Amp Link Hide-a-key Ignition key Oury Grips Frame is Powdercoated Steering Stem Powdercoat Stainless Steel Bolt Kit Stearing Stem Bearing Front Wheel Bearings Linkage rebuild kit Front & Rear Brakes A-arm Bushings Dust Covers Swingarm Bearing kit Front & Rear Shocks Powdercoating (hubs and front spindles) Lonestar Swingarm Laeger LT A-arms Lonstar Axle Lonestar Brake hub Lonestar sprocket hub Lonestar Locknut Tie-rod Ends Front Brake Calipers Powdercoat cases & cylinders New cases Kickstarter gear Polished clutch cover Wiring loom with work Shift drum Flywheel puller Voltage Regulator Waterbottle bracket Nerf Bars Trinity Heavy Duty clutch kit PWR Radiator Pro Design high flow impeller ac racing wide grab bar New shift shaft Stainless braided clutch cable primary gear & clutch basket Engine seal kit Gasket kit Dyna FS ignition with curves Trinity Stage IV head with 21cc domes V force 3 reed assembly 35mm 2 into 1 Trinity carb Trinity Stage IV stainless exhaust Sure shift kit Hot rods true & welded crank Trinity Stage 3 port Billet gas cap Billet grill ITP polished c series rims Powdercoat cylinders & case http://img.photobucket.com/albums/v202/s15driftking/TMO2.jpg http://img.photobucket.com/albums/v202/s15driftking/TMO5.jpg http://img.photobucket.com/albums/v202/s15driftking/TMO4.jpg http://img.photobucket.com/albums/v202/s15driftking/TMO3.jpg http://img.photobucket.com/albums/v202/s15driftking/TMO1.jpg Link to comment Share on other sites More sharing options...
Rustlestiltskin Posted April 1, 2009 Report Share Posted April 1, 2009 have you raced it? Link to comment Share on other sites More sharing options...
coryscobra Posted April 1, 2009 Report Share Posted April 1, 2009 Thats fucking bad. Banshees fly! Good luck with the sale. Link to comment Share on other sites More sharing options...
Diamonds Posted April 2, 2009 Author Report Share Posted April 2, 2009 have you raced it? no, honestly, it was built and just kinda sat there... it was more of a project than anything. Link to comment Share on other sites More sharing options...
Diamonds Posted April 21, 2009 Author Report Share Posted April 21, 2009 BUMP Link to comment Share on other sites More sharing options...
XChris1632X Posted April 22, 2009 Report Share Posted April 22, 2009 This makes me really miss my shee. Are those toomeys? Link to comment Share on other sites More sharing options...
Diamonds Posted April 22, 2009 Author Report Share Posted April 22, 2009 honestly, i let my co-worker use my account to post this. He's 100% legit. i will vouch for him. But, what are toomeys? hehe, sorry Link to comment Share on other sites More sharing options...
XChris1632X Posted April 22, 2009 Report Share Posted April 22, 2009 Toomeys are exhaust pipes. The cans look like toomeys but the pipes look like SST's almost. Its been awhile so I am not that fresh with them. Toomeys are a top end pipe, while FMF SST's are a midrange. Makes a huge difference. Will he take any trades? Edit: Just looked closer and they are not SST's. My vote is toomey, which is not really a MX type pipe. More of a top end pipe that most use in the dunes. Link to comment Share on other sites More sharing options...
Diamonds Posted April 22, 2009 Author Report Share Posted April 22, 2009 (edited) He is deff. into trades. here is his email tymoscat@maxhealth.com i will find out about the exhaust in about 15 mins. EDIT - exhaust is a trinity stage 4 Edited April 22, 2009 by Diamonds Link to comment Share on other sites More sharing options...
XChris1632X Posted April 23, 2009 Report Share Posted April 23, 2009 Sent him an email. Link to comment Share on other sites More sharing options...
Recommended Posts