Need help for v-band welding

[tristanlee85]

While I wish setting the car on fire was an option, not just yet...

 

http://www.plastikhosting.net/uploads/tristanlee85/broken_vband.jpg

 

Since this pretty much as to be done on the car to make sure the angle right, I was planning on tacking the v-band flanges together at the turbine, and then about 5" out from the turbine, cut the downpipe and weld in a new set of flanges for a v-band. The problem with the current location is that the v-band was always touching the header so it had a good bit of stress on it.

 

Basically what I am going to do is cut and tack this all up myself with my mig, and then hoping one of you fine fellers' can finish it up with a nice weld for me. I'll buy all the supplies needed and beer and dinner if you would like. I really can't afford $200 for a shop to do it. I'll be able to bring it by later in the evening or the weekend. Let me know if you're willing to help. Deals Gap is in 2 weeks.

[mrblunt]

Dude I told you I know a guy.

[Limitedslip7]

I can do it if you are willing to bring it to Marion. I cannot do it today because I am out of gas and Valley is already closed, but I could do it anytime tomorrow on.