Gergwheel1647545492 Posted September 23, 2009 Report Share Posted September 23, 2009 With my new harness im having to run the entire wiring harness down the back of the block and i want to protect it from the heat and such, do you think this would do the trick? the harness is about 3-4 inches away from the header, so there will be some heat, but hopefully not enough to melt any wires. http://www.jegs.com/i/Thermo+Tec/893/14025/10002/-1 Quote Link to comment Share on other sites More sharing options...
ponyjr1647545514 Posted September 23, 2009 Report Share Posted September 23, 2009 Go to Jegs. You can buy heat resistant wire covers, or you could wrap the headers too. http://www.jegs.com/p/Thermo-Tec/Thermo-Tec-Thermo-Flex-Sleeve-Insulation/746616/10002/-1 Quote Link to comment Share on other sites More sharing options...
Gergwheel1647545492 Posted September 23, 2009 Author Report Share Posted September 23, 2009 Have you used it before? does it work well? Did you see the link i posted? its to the same stuff you posted. Quote Link to comment Share on other sites More sharing options...
Twistedrx7 Posted September 23, 2009 Report Share Posted September 23, 2009 do it right...http://www.mcmaster.com/#sleeving/=3rfhsa Quote Link to comment Share on other sites More sharing options...
KillJoy Posted September 23, 2009 Report Share Posted September 23, 2009 Wrap the Headers FOR SURE! ESPECIALLY if they are not installed yet KillJoy Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted September 24, 2009 Report Share Posted September 24, 2009 heat sleeve it and wrap the headers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.