boostedgtp Posted April 24, 2010 Report Share Posted April 24, 2010 Where can you buy one of these in columbus? Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted April 24, 2010 Report Share Posted April 24, 2010 tool truck napa Quote Link to comment Share on other sites More sharing options...
TurboRust Posted April 24, 2010 Report Share Posted April 24, 2010 to hold it still while getting the crank bolt loose? I use a set of 3 ft lock jaw channel locks and they've always done the trick. lemme know if you wanna borrow them Carl Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted April 24, 2010 Report Share Posted April 24, 2010 i warm the bolt up to release the lock tight... then impact out the bolt. Quote Link to comment Share on other sites More sharing options...
SiColin Posted April 24, 2010 Report Share Posted April 24, 2010 i warm the bolt up to release the lock tight... then impact out the bolt. Thats what I do to but usually my impact takes it off with no problem. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted April 24, 2010 Report Share Posted April 24, 2010 Thats what I do to but usually my impact takes it off with no problem. that has alot to do with how many psi, and how much volume of air you can get to your gun. Quote Link to comment Share on other sites More sharing options...
boostedgtp Posted April 24, 2010 Author Report Share Posted April 24, 2010 my 1/2 gun just didnt have enough ass, i borrowed a 3/4 gun and it worked. Thanks for the help tho derek and rob. The last couple I have done I was able to use 1/2 no problem, this one just had to fight a little more. I did call the 161 napa and they have the tool for like 48.00 if anyone needs it. Quote Link to comment Share on other sites More sharing options...
SiColin Posted April 25, 2010 Report Share Posted April 25, 2010 that has alot to do with how many psi, and how much volume of air you can get to your gun. I use a corded dewalt 1/2 impact. I have yet to run into a honda crank pulley bolt or axle nut that it can't get off. PB blaster always helps too. Damn 48 bucks aint to bad of a deal for the tool. Good to know. Quote Link to comment Share on other sites More sharing options...
DaddyBuiltRacing Posted April 25, 2010 Report Share Posted April 25, 2010 Make sure you retighten that bitch after about 20miles of driving or else its gonna fall off lol. I have seriously seen about 10 Honda crank pullies come off while driving because they weren't re-tightened (I had one do it on a sohc vtec once cause I failed to re-torque it) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.