Painted the first part for the new camaro motor

[Mattsv8]

well. i was wanting to try out the blue anodize paint so i painted the timing cover.

it looks good and should match the car.

http://i33.photobucket.com/albums/d71/Mattsv8_03/89%20Chevy%20Camaro%20build%20up/SSPX4676.jpg

http://i33.photobucket.com/albums/d71/Mattsv8_03/89%20Chevy%20Camaro%20build%20up/SSPX4677.jpg

http://i33.photobucket.com/albums/d71/Mattsv8_03/89%20Chevy%20Camaro%20build%20up/SSPX4679.jpg

http://i33.photobucket.com/albums/d71/Mattsv8_03/89%20Chevy%20Camaro%20build%20up/SSPX4678.jpg

ill get one of it in the sun looks way better in the light.!

[nurkvinny]

Did you scruff that cover up first?

 

Looks decent. BTW, I get the need for the round indent in the top (near where the cam button goes), but why do the covers have the three lines heading away from there? Always wondered.

[Mattsv8]

there is a welded in steel brace behind that. its a cam stop for roller cams. ill take a pic of the back for ya. its i believe .090 steel and welded behind it.

[Mattsv8]

http://i33.photobucket.com/albums/d71/Mattsv8_03/89%20Chevy%20Camaro%20build%20up/SSPX4701.jpg

these work great and the clearence is usually spot on with the small roller cam button

[Mattsv8]

lol im stupid. i forgot i bought this for the camaro motor!

http://i33.photobucket.com/albums/d71/Mattsv8_03/SSPX4360.jpg

ahh well 30 bucks to see how it looks is good too. the camaro will be the regular 89 camaro iroc blue. with no striping though im gonin to try and fit it all under the stock hood. my moving the motor a little back and down on motor plates.

will have bmr k member for rack and pinion. plus im going to try and run full 4" mufflex exh over the axel then 5" in the engine bay. im getting excited for winter. but not excited about putting the s10 in storrage for the winter.