Jump to content

2001 Pontiac Grand Prix GTP


Main3s
 Share

Recommended Posts

Well Im in the process of moving to AZ so I need to sell my car. Some of you may know it, it's a rare silver 2001 Pontiac Grand Prix GTP coupe, with 200,xxx miles on the body.

Asking Price - $2,800 (O.B.O). Not interested in trades need $$$$ to move. Title in hand ready to sell, no BS please.

 

I'm the second owner of the car. I bought it as a lese back in 2004 and have owned it since. I raced it for a while with a PB of 12.73 @ 116 in the 1/4. But that was a few years ago. Since then the car has been pretty much returned to stock and continues to be my Daily Driver

 

There are a few minor issues

- The body has some dents and the front drivers side bumper is cracked. (I slid off into a drainage ditch this past winter :( and cracked it)

- The windshield is also cracked, straight accross. (rock chip gone unattended)

- Needs new breaks. I would have done them myslef, but my new job in AZ starts August 1st and I just never had the time :(

- Needs new relay for the fuel pump harness. The car still runs and drives fine, it just gets slightly lean at the top of shift points mainly 2-3.

- 3 of the 4 tires are in very good shape, however the drivers rear does have a leak.

- No AC, but the heat does work.

 

Now for the good.

-In 2008 the car recieved a newer engine and rebuild from a 2003 GTP. That was shortly after it's racing days were over.

- Transmission was completley rebuilt in the spring of 2011 and includes the remaining warrenty and reciepte info.

- New Battery (June 2011)

- New Starter (June 2011)

- New Altanator (June 2011)

- New S/C belt ( June 2011)

- New idler pulley (June 2011)

- New acces. belt ( June 2011)

- Includes scan guage. (Reads the PCM through the OBDII port.)

- Full SLP stainless CAT back exhaust including mufflers

- New drivers side window motor, track and switch. (june 2011)

 

Mechanicly the car is sound. I also have a lot of extra parts that come with the car including the GTP floor mats, the owners manual, 3 official GM service manuals, spair fuse box and fuses, S/C pulleys, belts, gaskets, fuel rails and tons of other small parts that I've collected for the car over the years. Thanks!

 

 

 

http://i49.photobucket.com/albums/f279/cmaines01/photo6.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo6.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo4.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo3.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo2.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo8.jpg

http://i49.photobucket.com/albums/f279/cmaines01/photo7.jpg

Edited by super_gtp
Link to comment
Share on other sites

Will you sell the s/c pulleys and belts separate ?

 

Let me see which pullies I still have for the car. I believe they're all 3.2 and smaller. But if you're still interested, Id sell just the pullies and belts.

Link to comment
Share on other sites

Let me see which pullies I still have for the car. I believe they're all 3.2 and smaller. But if you're still interested, Id sell just the pullies and belts.

 

I'm interested just let me know what size they are and how much you want for then

Link to comment
Share on other sites

Please send me pics, jasonebright@sbcglobal.net

 

Hey Jason,

I emailed you a few pictures. (same ones added to the post)

 

Chris,

 

I would go to Arizona for a funeral and come back. Best of luck my friend.

 

Thanks Brian! But its not all bad, lots of rust free mustangs out here in the desert! :p

 

I'm interested just let me know what size they are and how much you want for then

 

Sorry for the delay on the pullies. I'm having my roomate check the sizes on them. I'll let ya know ASAP. $15 a pulley.

Link to comment
Share on other sites

  • 2 weeks later...
I will take both pm me your phone number please do you have the belts ? Also would you part with the scan gauge ?

 

Hey sorry for the delay, I sent you a PM. I was in the process of moving out west. If youre wanting the extra belts you're more then welcome to take a look at the sizes and u can have em for $5 a piece. As for the scan guage, it's already wired into the car, so I'm not looking to sell it seperatly.

Link to comment
Share on other sites

  • 2 months later...
The pulleys gone? What extra fuel rails do you have?

 

Sorry, but I'm not looking to sell the parts seperatly. I'm in AZ now and my Dad has the car with all the extras. I don't really want to have him try and part a bunch of things out... But I'll make you a deal. $2,000.00 for the pullies and other parts and I'll throw in the car FREE of charge. ;)

Link to comment
Share on other sites

can this beat a stock 1997 piece of shit honda, if so phil could use an upgrade.

 

The "kill list" of cars isn't too long at this point, but a beat stock 97

POS Honda is on it. Lol. It still has 1:9 roller rockers and nice open exhaust.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...