Leaderboard

Ok, it is ready for tours. Got the floor in today. Done until spring when I may drywall it except for adding a plate for the centerstand.

Woah hey, hi. CR had moved so here's a Big'ole update on the car. Finally got the Replica SV6 spoiler at the beginning of 2022, made some little 3d printed plugs for the holes from the stock spoiler.. Recently had to replace the radiator after the top tank split in half, while I had it apart I went ahead and refinished the OE headlights, sanded all the original coating off with 5000 grit, buffed them out and then wrapped the lenses with Clear vinyl. and cut out the backing of the lower grille to the left and right to open it up for a later mod. Scotchgarde on the driver side and Vvivid on the passenger side....Because I accidentally ripped the expensive stuff. Oh yeah and April of this year I finally did some go fast mods. Summit 8715r cam, BTR .660 dual springs, .105 wall pushrods, M365 oil pump, Billet oil gallery barbell, Cloyes timing set, Comp Trunnions, ARP bolts where OE was/could not be reused, Stainless works Long tubes and all new gaskets + internal seals/orings... While I was apart also did new poly engine mounts and the Camaro trans pan Tried for a few months to tune it myself, but the Gen4 stuff just isn't as easy as the Gen3...So I had to take it to get a real tune and made a cool 406hp on 88 Octane This was a clip still on my....not so great tune. And these have been sitting in a box since July of last year, just haven't had the extra money to install them, plus I haven't been able to get my power coating stuff set up yet.

Looks great! But what's the deal with the catch pan for the tool box? Leaking oil? Made by Harley-Davidson? 😏