Dave1647545494

just going to rebuild this one n/m

not trying to be a dick, but couldn't you just cross reference part numbers at work?

 

everything at work tells me 1994 is a 1 year trans because of the cooler line location change the following year and an electronics change the year before

One of my pistons in my wilwoods is bad. Any shops around that specialize in this?

 

order a seal from wilwood and do it yourself.

 

remove the caliper and drain it. put some compressed air in the hole where the brake hose was and the piston will pop out. the seal changes just like a grease seal in a rotor. lightly lube the piston with brake fluid and reinstall it and your all done.

nobody knows anything about these?

Don't you mean 3.5" shells? I have an express that isn't a magnum, feeds 3".

 

12 gauge only comes in 2 3/4 or 3"

 

if you want to step up to 3 1/2" shells your gonna need to leave popcan police pump action junk at home and get yourself 10 gauge.

 

 

Remington might tell you there is no extra benefit in a magnum round but a 3" shell will cut a wood post in half at 25 yards and 2 3/4" shell just peppers it.

 

honestly that price is pretty high for what is most likely a heavily used shotgun you can pick up an 1100 for a little more and it does all the work for you.

ok the trans is starting to die in my 94 Chevy c3500 and I just want to swap it out for a lower mileage one. How new of a trans can i get and still have it be a plug n play deal on the electronics? I can change drive shafts and cooler lines but prefer to not have to open up the trans to do more than a new filter.

 

 

thanks

Can you tune the Ecoboost Flex too?

I've got a 2001 Kia Sephia. I'd probably let go of for that price. its 1.8 5speed air works. I'm supposed to pick up another car next weekend so it could be ready to go in a week or so. I commute almost 40 miles a day in it without any problems.

doesn't bother me a bit as long as it runs out ok.... motorswaps are fun

sold!

looks like you already found one but if not we keep those in stock

big obo on these any reasonable offer accepted just don't want to store them

350tbi 4l80e 200+k miles trans is a goodwrench replacement unit motor runs strong. rear floor rusted through bad rust throughout body... good for parts demolition derby or maybe rough truck

 

$750 obo

 

 

pics available upon request

200k 3.5L auto Leather interior

 

this car is a beater.....

 

engine and trans replaced a year or two ago new fuel pump starter timing belt water pump... decent tires

 

the clear is peeling in spots

 

 

$1500 obo

 

will post pics later today

http://www.autoblog.com/2009/09/24/shed-a-tear-for-clunkers-that-deserved-better/

This will make you cry

 

 

 

that list had 52 caddy allante's on it I hope they finally crushed them all lol

should just be able to call a body shop and ask for a hood box

1 14" tube style $10.00

 

1 20" tube style with built in vcr $15.00

 

1 20" tube style with built in dvd $20.00

 

1 36" tube style $50.00

 

 

 

614-354-0635 all prices are obo

 

thanks

will you do $150 on the 17" wheels?

its a steel self tapping insert a 3valve style spark plug and a new coil boot it shouldn't take much longer to install than it takes to change a plug

any place that sells bulk gas like columbus welding supply can recert a bottle

check for injector pulse with a noid light yet? a leaky hedder gasket on that cylinder will make it miss too.

Dorman makes a nice repair kit for those we keep it in stock

I have the complete remover set for those if you didn't get it off yet... run it by the house take 15-20 minutes to get ya fixed up.

I must be the only one who sees the steel sticking out of the tire in the middle picture... it looks like a broken belt in the tire near the sidewall have it inspected at a tire shop.

I will take it.... where do you want to meet me at?