I installed a 10" pusher fan on my condensor and have a wiring question for the wiring gurus on the forum! I have the fan wired up through the stock A/C relay that is controlled by the mazda interlock switch. When I probed it out with my test light prior to pinning the wire and when I had the switch pressed I had light(12v.) and durng the release I did not. So I wire the fan up and press the switch and it works, release the switch and the fan stays on. I have to remove the key from the ignition in order to turn the fan off. If I start the car without the switch pressed in no fan. Can I add some sort of bleeder resistor so the fan will shut off when I release the switch. The fan is 7.0 amps, I'm using 10ga. wire with a good ground. Any ideas???