zeitgeist57 Posted December 10, 2004 Report Share Posted December 10, 2004 The hydraulic clutch in my truck is acting a little funny...it only disengages the clutch scarily close to the floor; I almost have to fully press the pedal down to shift. I have not visually inspected the master cylinder or slave cylinder...but...is there anything I can do to adjust the clutch? Thanks! Quote Link to comment Share on other sites More sharing options...
Browning Posted December 10, 2004 Report Share Posted December 10, 2004 I though on hydraulic clutches you could only bleed them...? Quote Link to comment Share on other sites More sharing options...
Tractor Posted December 10, 2004 Report Share Posted December 10, 2004 You may be able to increase the lenght of the push rod going into the master cylinder from the pedal. It may have an adjusting bolt on the rod somewhere. Evan Quote Link to comment Share on other sites More sharing options...
Doug1647545489 Posted December 10, 2004 Report Share Posted December 10, 2004 Originally posted by Tractor: You may be able to increase the lenght of the push rod going into the master cylinder from the pedal. It may have an adjusting bolt on the rod somewhere. Evanyep free play should be about 3/4" - 1" Quote Link to comment Share on other sites More sharing options...
Alex1647545498 Posted December 11, 2004 Report Share Posted December 11, 2004 It should look something like this. http://www.mr2ownersclub.com/online_parts_catalog/Transaxle/clutch%20master%20cylinder.GIF 31453 is connected to your pedal. You should be able to disconnect it from your pedal and "screw" it to adjust it on 31451. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.