Jump to content

ford 2.3 engine, trans, wiring, and ecu


Gergwheel1647545492

Recommended Posts

FWIW Its a Merkur XR4Ti wiring harnes that is fairly complete. The lower intake has been partially ported and the upper has begun to be gutted. It has an un-cracked E7 exhaust manifold, just no turbo.

 

 

I'll sell it for $98 and I'll deliver. :D;)

Link to comment
Share on other sites

Originally posted by buckeye:

are you sure that it is a t5 becouse the XR4TI's ran t9's they were junk

The T-5 was from a Turbo coupe and its gone.

 

 

The motor SHOULD last a while, we NEVER ran it (it sat for 4 years now). We got it from a sub 100k mile XR4Ti from the junkyard. I see no reason it wouldnt last, however I havent ran it so I dont know.

 

The motor and harness for $70, come pick it up. smile.gif

 

Call if you'd like

(740) 971-4901

 

Rob

Link to comment
Share on other sites

Originally posted by gergwheel:

I'll give ya the motor, harness, AND ECU for 70 bucks smile.gif

 

gotta love screwing rob smile.gif

 

call me

(740) 272-1191

This man will rip you off :mad:
Link to comment
Share on other sites

Originally posted by Lustalbert (more used cars than CR):

just for grins, is it the same bolt patern as the mazda engines (for example 1.6l or 1.8l dohc from an escort)

pm me

thanks

I dont think so. Its based off the pinto 2.3L and 2.0L motors.
Link to comment
Share on other sites

  • 4 weeks later...
Guest
This topic is now closed to further replies.
×
×
  • Create New...