MrMeanGreen Posted April 6, 2006 Report Share Posted April 6, 2006 I need 6+ inches of 3.5" diameter stainless steel or similar pipe. This is going to be a replacement for my MAF since I'm running speed density. Thanks Link to comment Share on other sites More sharing options...
Guest Removed Posted April 6, 2006 Report Share Posted April 6, 2006 use aluminum, think about the heat transfer! Link to comment Share on other sites More sharing options...
Mensan Posted April 6, 2006 Report Share Posted April 6, 2006 Aluminum would transfer engine heat into the intake air. Link to comment Share on other sites More sharing options...
Tinman Posted April 6, 2006 Report Share Posted April 6, 2006 I have some aluminized here at the house. Or if you can wait untill Monday, I can roll up a piece of 20 ga. #4 brushed finish stainless. Link to comment Share on other sites More sharing options...
Mitch Posted April 6, 2006 Report Share Posted April 6, 2006 I may be able to help you out I have the stainless pipe that ran from the ypipe to where it bent up to go over the axle from when I installed the magnaflow exhaust on my Z28. I don't remember if it was 3 in or 3.5in. I'll measure when I get home. Price= one $8.95 bottle of black velvet. (anyone wondering why it didn't get installed when I put in the magnaflow, the previous owner evidently had a nice exhaust on it but either he took the catback off before he traded it in or the dealer needed to try to quiet it down and put some ghetto muffler in its place. I saved myself some work and reused the midpipe.) Link to comment Share on other sites More sharing options...
MrMeanGreen Posted April 6, 2006 Author Report Share Posted April 6, 2006 Lemme see what Matt has, I've seen his "collection" I'm also probably gonna have it powercoated for looks and heat insulation. Link to comment Share on other sites More sharing options...
Mensan Posted April 7, 2006 Report Share Posted April 7, 2006 I'm also probably gonna have it powercoated for looks and heat insulation. How do you "power"coat engine parts, and where can I get it done? Link to comment Share on other sites More sharing options...
Mitch Posted April 7, 2006 Report Share Posted April 7, 2006 Sorry, its only 3 in. diameter Link to comment Share on other sites More sharing options...
NWill Posted April 7, 2006 Report Share Posted April 7, 2006 How do you "power"coat engine parts, and where can I get it done? IPS Motorsports at 1740 Harmon http://www.ipsmotorsports.net Link to comment Share on other sites More sharing options...
Recommended Posts