Need help with an integra

[V8 Beast]

Who can run a diagnostic on an integra and how much will it cost? Dearlership is asking for $75-$100...

[Zach1647545520]

what's wrong with it? Year?

[Guest Removed]

what's wrong with it? Year?

 

plus 1

 

if its a 95 down you can pull codes your self.

 

if its a 96 up siwng it thru auto zone or the like

[Ef8sirJunkie]

2 pin connector on the right kick panel next to the ecu, loop this connector, must count the flashes they are long and short. if obd-2 vehicle autozone does free diagnostics.

[V8 Beast]

^^^Is that how you check it on the 95's?

[Jizzle Juice]

Yup count flashes

[Evolved8]

What going on with it brian, Let me know ill get you taken care of

[Ef8sirJunkie]

yep you have to count the flashes from the check engine light after you loop the 2 wires.

 

 

 

-----CEL # List-----

1 O2A - Oxygen sensor #1

2 O2B - Oxygen sensor #2

3 MAP - manifold absolute pressure sensor

4 CKP - crank position sensor

5 MAP - manifold absolute pressure sensor

6 ECT - water temperature sensor

7 TPS - throttle position sensor

8 TDC - top dead centre sensor

9 CYP - cylinder sensor

10 IAT - intake air temperature sensor

12 EGR - exhaust gas recirculation lift valve

13 BARO - atmospheric pressure sensor

14 IAC (EACV) - idle air control valve

15 Ignition output signal

16 Fuel injectors

17 VSS - speed sensor

19 Automatic transmission lockup control valve

20 Electrical load detector

21 VTEC spool solenoid valve

22 VTEC pressure valve

23 Knock sensor

30 Automatic transmission A signal

31 Automatic transmission B signal

36 traction control found on JDM ecu's

41 Primary oxygen sensor heater

43 Fuel supply system

45 Fuel system too rich or lean

48 LAF - lean air fuel sensor

54 CKF - crank fluctuation sensor

58 TDC sensor #2

61 Primary oxygen sensor

63 Secondary oxygen sensor circuit

65 Secondary oxygen sensor heater wire (black wires)

67 Cat Converter

71 random misfire cylinder 1

72 random misfire cylinder 2

73 random misfire cylinder 3

74 random misfire cylinder 4

80 EGR Valve/Line

86 ECT sensor - Cooling System

91 Fuel Tank pressure sensor

92 EVAP Solenoid/Valve/Vacuum Lines

 

hope that helps

[V8 Beast]

Thanks for the replies everyone. I'll update the post later this week if I need anymore help.

[Guest Removed]

Thanks for the replies everyone. I'll update the post later this week if I need anymore help.

 

if you get stuck, just swing by the shop and i'll point you in the right direction

[V8 Beast]

I heart CR

[Ef8sirJunkie]

I heart CR

 

Did you get this issue figured out?

[V8 Beast]

I wont be able to do it until this weekend. I'm hoping for an o2 sensor or something minor.

[V8 Beast]

So I did it and the ABS started blinking instead of the check engine light. Appeared to blink 19 times.

[Guest Removed]

So I did it and the ABS started blinking instead of the check engine light. Appeared to blink 19 times.

 

then you jumpered the wrong plug my man

[V8 Beast]

Car never had the check engine light on. The maintenance required light was what was actually lit. I did the paperclip thing anyway to see what would happen and the ABS flashed repeatedly.

[Guest Removed]

maintenance required light is easy to make go away.

[V8 Beast]

I know, told him it probably wasnt reset with the last oil change.

[Guest Removed]

I know, told him it probably wasnt reset with the last oil change.

 

thats not a oil change based light tho...mileage interval