V8 Beast Posted August 31, 2009 Report Share Posted August 31, 2009 Who can run a diagnostic on an integra and how much will it cost? Dearlership is asking for $75-$100... Quote Link to comment Share on other sites More sharing options...
Zach1647545520 Posted August 31, 2009 Report Share Posted August 31, 2009 what's wrong with it? Year? Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted August 31, 2009 Report Share Posted August 31, 2009 what's wrong with it? Year? plus 1 if its a 95 down you can pull codes your self. if its a 96 up siwng it thru auto zone or the like Quote Link to comment Share on other sites More sharing options...
Ef8sirJunkie Posted August 31, 2009 Report Share Posted August 31, 2009 2 pin connector on the right kick panel next to the ecu, loop this connector, must count the flashes they are long and short. if obd-2 vehicle autozone does free diagnostics. Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted August 31, 2009 Author Report Share Posted August 31, 2009 ^^^Is that how you check it on the 95's? Quote Link to comment Share on other sites More sharing options...
Jizzle Juice Posted August 31, 2009 Report Share Posted August 31, 2009 Yup count flashes Quote Link to comment Share on other sites More sharing options...
Evolved8 Posted August 31, 2009 Report Share Posted August 31, 2009 What going on with it brian, Let me know ill get you taken care of Quote Link to comment Share on other sites More sharing options...
Ef8sirJunkie Posted September 1, 2009 Report Share Posted September 1, 2009 yep you have to count the flashes from the check engine light after you loop the 2 wires. -----CEL # List----- 1 O2A - Oxygen sensor #1 2 O2B - Oxygen sensor #2 3 MAP - manifold absolute pressure sensor 4 CKP - crank position sensor 5 MAP - manifold absolute pressure sensor 6 ECT - water temperature sensor 7 TPS - throttle position sensor 8 TDC - top dead centre sensor 9 CYP - cylinder sensor 10 IAT - intake air temperature sensor 12 EGR - exhaust gas recirculation lift valve 13 BARO - atmospheric pressure sensor 14 IAC (EACV) - idle air control valve 15 Ignition output signal 16 Fuel injectors 17 VSS - speed sensor 19 Automatic transmission lockup control valve 20 Electrical load detector 21 VTEC spool solenoid valve 22 VTEC pressure valve 23 Knock sensor 30 Automatic transmission A signal 31 Automatic transmission B signal 36 traction control found on JDM ecu's 41 Primary oxygen sensor heater 43 Fuel supply system 45 Fuel system too rich or lean 48 LAF - lean air fuel sensor 54 CKF - crank fluctuation sensor 58 TDC sensor #2 61 Primary oxygen sensor 63 Secondary oxygen sensor circuit 65 Secondary oxygen sensor heater wire (black wires) 67 Cat Converter 71 random misfire cylinder 1 72 random misfire cylinder 2 73 random misfire cylinder 3 74 random misfire cylinder 4 80 EGR Valve/Line 86 ECT sensor - Cooling System 91 Fuel Tank pressure sensor 92 EVAP Solenoid/Valve/Vacuum Lines hope that helps Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted September 1, 2009 Author Report Share Posted September 1, 2009 Thanks for the replies everyone. I'll update the post later this week if I need anymore help. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted September 1, 2009 Report Share Posted September 1, 2009 Thanks for the replies everyone. I'll update the post later this week if I need anymore help. if you get stuck, just swing by the shop and i'll point you in the right direction Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted September 1, 2009 Author Report Share Posted September 1, 2009 I heart CR Quote Link to comment Share on other sites More sharing options...
Ef8sirJunkie Posted September 2, 2009 Report Share Posted September 2, 2009 I heart CR Did you get this issue figured out? Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted September 2, 2009 Author Report Share Posted September 2, 2009 I wont be able to do it until this weekend. I'm hoping for an o2 sensor or something minor. Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted September 7, 2009 Author Report Share Posted September 7, 2009 So I did it and the ABS started blinking instead of the check engine light. Appeared to blink 19 times. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted September 7, 2009 Report Share Posted September 7, 2009 So I did it and the ABS started blinking instead of the check engine light. Appeared to blink 19 times. then you jumpered the wrong plug my man Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted September 7, 2009 Author Report Share Posted September 7, 2009 Car never had the check engine light on. The maintenance required light was what was actually lit. I did the paperclip thing anyway to see what would happen and the ABS flashed repeatedly. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted September 7, 2009 Report Share Posted September 7, 2009 maintenance required light is easy to make go away. Quote Link to comment Share on other sites More sharing options...
V8 Beast Posted September 7, 2009 Author Report Share Posted September 7, 2009 I know, told him it probably wasnt reset with the last oil change. Quote Link to comment Share on other sites More sharing options...
Guest Removed Posted September 7, 2009 Report Share Posted September 7, 2009 I know, told him it probably wasnt reset with the last oil change. thats not a oil change based light tho...mileage interval Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.