jarvismb Posted August 3, 2009 Report Share Posted August 3, 2009 Looks like a fun little project. Check out the power density calcs at the bottom.People have been predicting the death of the internal combustion engine for at least 50 years. Thing is, most of the folks making the predictions have themselves died, or been silenced by the fact that ICE is still here and it's better than ever. Still, the technology could be improved. All that sound and all that heat is just inefficient waste. And what about parasitic losses, like power steering pumps and valve train? Well, some OEMs (like Ford) are switching to mileage boosting electronic steering to save some MPG. However, electric valves are a long ways off. Not only would they be infinitely variable, but removing the chains, rods and springs needed to run conventional valves would increase mileage by 20%, at least. And that's just one route.Another is the EcoMotors International (EM) opoc engine, aka open piston, opposed cylinder. Here's how it works. Instead of an I or a V pattern, EM's opoc is laid out like a two-cylinder boxer engine. However, each cylinder contains two pistons, and they are facing each other. This gives you four rods turning the crankshaft, with no cylinder heads and no valve train (for the record, we're not sure how fuel/air enters and exits). The opoc engine is also a two-stroke, guaranteeing lots of quick torque, but it "runs as a fully balanced 4-cylinder 4-stroke engine." Shrinky-dinkying the engine has a whole host of other benefits that EM lumps together under the banner, "power density." They include: lower weight and smaller size, fewer materials, less friction, higher MPG, lower missions and less heat rejection. And as the engine is working against itself, there's plenty of built in noise cancellation. Power? Burning diesel, two 100 mm cylinders produce 325 hp and 664 lb-ft of torque @ 2,100 rpm. Nice. And thanks to Eugene for the tip! [source: EcoMotors] Quote Link to comment Share on other sites More sharing options...
Disclaimer Posted August 3, 2009 Report Share Posted August 3, 2009 I like to read about ICE and powertrain tech. I've heard about this engine, I'm actually following what happens with the Scuderi Split-Cycle engine... I think it's much less of a leap in tech and manufacturing to do that.http://jalopnik.com/5219985/scuderi-split+cycle-engine-could-make-140-hp-per-literwww.ScuderiEngine.com Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.