Jump to content

ic piping


Brandon

Recommended Posts

i just ordered my spearco ic and i was wondering who on the board can make custom plumbing for me. and then how much. the size is 26x6x3 and is a bar plate ic. it will be going into my sig pic in about 4-5 months i am just getting a jump on everything i need so i can do the engine swap fast and efficent. thanks :D
Link to comment
Share on other sites

Found that when you have to cut into the bend to make a turn section that the jegs bends are kinda ovalized which makes welding them a pain because if you dont mate the piece you cut off sometimes you will get gaps. The pipes I picked up from road race engineering turned out to be a lot nicer than the jegs one and only cost a bit more. I'm waiting on my friend to throw up the pics I took the other night and I will post them up for you.

 

-jeff

Link to comment
Share on other sites

  • 2 weeks later...

Forgot to post these before. I will snap some shots of the completed ones tomorrow when I head over to take more pictures.

 

http://www.platinumpc.dhs.org/pics/pics/jeff/Picture%20019.jpg

 

http://www.platinumpc.dhs.org/pics/pics/jeff/Picture%20021.jpg

 

 

-jeff

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...