Guest relvinnian Posted September 2, 2002 Report Share Posted September 2, 2002 Here are the basic specs on the new Haltech E11: * Full 32 bit system * Comes with mil-spec wiring * Halwin3 Windows based programming software only - there will be no DOS version. * Enough drivers to run a V8 with sequential injection AND direct fire ignition. 6-cylinder sequential injection with 6-coil sequential direct fire ignition is no problem. * Individual injector and ignition trims * On-board wide band control. * CAN support * Injection time down to 0.004ms , ignition timing down to 0.1 degrees. * Variable load and rpm points. 32x32. * Full 720 degree phase timing control of injectors with choice of End or Start of Injection. * TPS, 1,2,3,5 Bar MAP, Air Flow Meter all available as load inputs. * Advanced throttle pump control, fully mappable. * Built in firmware update facility and full diagnostics even for the trigger. * Idle control has a tonne more features. * 3-rotor AND 4-rotor full support. The 20B is completely covered and will run staged and sequential injection along with 6-coil direct fire ignition with full 32x32 map for trail split timing control. * Those of you with a rotary, the Oil Metering Pump is supported and allows mapping of the oil injection system ! * Dual on-board maps are directly supported. * On board datalogging. No need for a laptop to be connected to do datalogging. Log rate up to 250 samples per second !!! * Boost control is 3D mappable. * Many more trigger systems covered, with an updated internal RA system as well. Motronic support built in. * 5x Digital Inputs , 4x dedicated PWM with spare outputs available, 2x AuxOuts , 8x Spare A/D inputs. * Software comes on CD and manual comes in PDF format. * Many more features to come in future as firmware updates. Here is a pic: http://www.hitman.hm/E11-Screen1.jpg Quote Link to comment Share on other sites More sharing options...
Joe Posted September 2, 2002 Report Share Posted September 2, 2002 sweet jesus!!! i will have to get one of those. the extra features certainly justify the extra 600 dollars! Brian, does RPM Performance Centre carry them, and whats the URL for them? Thanks.. Quote Link to comment Share on other sites More sharing options...
Guest Computerguy5 Posted September 4, 2002 Report Share Posted September 4, 2002 Whats the retail on one of those? And when are they available? I was gonna build my own engine management system (I'm a geek and capable of doing so), but if the price is right, I think I'll just snag one of those instead... Quote Link to comment Share on other sites More sharing options...
Guest relvinnian Posted September 5, 2002 Report Share Posted September 5, 2002 Joe, I'm sure they will when it's released on the 16th. Haltech is Australia based, so RPM PC will be one of the first to recieve them. BTW, please check your PMs, it's important. -Brian Quote Link to comment Share on other sites More sharing options...
Guest Computerguy5 Posted September 6, 2002 Report Share Posted September 6, 2002 Damn too many "Joe"s on here... Quote Link to comment Share on other sites More sharing options...
Bad Posted September 8, 2002 Report Share Posted September 8, 2002 I got a woooooody over it. It's nice they finally have a windoze version of the software going. Anyone know if it's windoze v3.1? The 32-bit is finally sweet. It would be too hard to give up my PFC+datalogit. Hmmm. I do know someone that would buy my old unit... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.