Cordell Posted December 13, 2012 Report Share Posted December 13, 2012 Kenwood head unit, just over a year old. USB port, 3 pre-amp outputs, bluetooth, remote took it out of my Silverado before I traded it, works perfectly, I have everythig to hook it into a late model GM, $100 without extra GM crap http://i405.photobucket.com/albums/pp133/ND2RACE/for%20sale/CIMG0355.jpg Pioneer head unit, about 5-6 years old, been sitting for 3-4. plays WMAs, MP3s on disk, works fine, took out of my Camaro because I like the look of stock. $50 http://i405.photobucket.com/albums/pp133/ND2RACE/for%20sale/CIMG0357.jpg Pioneer 3-way 4x6" speakers, about 3-4 years old, been sitting for 2-3 removed from my S10 dash before I junked it, work fine. $25 http://i405.photobucket.com/albums/pp133/ND2RACE/for%20sale/CIMG0353.jpg Pioneer 3-way 6x9" speakers, about 6 yeas old, sitting for 5 removed from my Park Avenue after I totaled it, work perfectly, $50 http://i405.photobucket.com/albums/pp133/ND2RACE/for%20sale/CIMG0349.jpg Rockford Fosgate 2 channel amp, removed from my brothers truck not sure how old it is, worked fine when removed, we have no use for it says RF2002 on it, I think it's rated at 200x2 at 2 ohms not sure, $50 http://i405.photobucket.com/albums/pp133/ND2RACE/for%20sale/CIMG0350.jpg Memphis 10s in box with Rockford 360a2 amp, had for a long time, don't use it dual 4 ohm subs, bridged amp, works good, $100 http://i405.photobucket.com/albums/pp133/ND2RACE/for%20sale/CIMG0338.jpg Link to comment Share on other sites More sharing options...
Cordell Posted December 15, 2012 Author Report Share Posted December 15, 2012 Bump, I'll take reasonable offers on ths stuff since it's just going to keep sitting around. Link to comment Share on other sites More sharing options...
gillbot Posted December 15, 2012 Report Share Posted December 15, 2012 RF2002 Features and Specs Performance RMS Power Output (Watts x Channels) 50 x 2 Peak Power Output (Watts x Channels) 300 x 2 Power at 2 Ohms (Watts x Channels) 100 x 2 Bridged Power (Watts x Channels) 200 x 1 Minimum Impedance Bridged 4 Minimum Impedance Unbridged 2 Best Frequency Response 20-200k Hz THD at Rated RMS Power 1% Signal to Noise Ratio 80 dB Input Voltage 14.4v Features Amplifier Class AB Low-Pass Crossover Frequency 40-400 Hz Low-Pass Slope (dB/octave) 12dB/oct High-Pass Crossover Frequency 40-400 Hz High-Pass Slope (dB/octave) 12dB/oct Bass Boost No Bass Boost Frequency N/A Fan Cooled No Fuse Rating 30 x 1 Speaker Level Inputs No Preamp Outputs 1 pair Width (inches) 11-5/8 Height (inches) 2-1/2 Depth (inches) 11-3/16 360a2 Details: stereo, bridged mono, or Tri-Way output 360 watts x 1 in bridged mode 180 watts x 2 at 2 ohms DSM technology TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise between the head unit and the amp MEHSA mounting technology NOMAD advanced protection circuitry monitors temperature, voltage, current and impedance, and provides "intelligent" shut-down protection without limiting system performance TRANS-ana circuit designs keep voltages low and signal paths simple in the pre-amp section, for minimum distortion and maximum musicality INDIGO guarantees the highest possible power output under all conditions, by leaving the power supply unregulated at high input voltages (engine running), and loosely-regulated at lower voltages (engine off, drawing on your battery) speaker-level inputs 100 dB signal-to-noise ratio low-pass/high-pass crossovers variable from 50-210 Hz Punch bass variable 0-18 dB at 45 Hz 40 amp fuse 12-1/4"W (9" w/o endcaps) x 2-11/16"H x 9-11/16"L Link to comment Share on other sites More sharing options...
Green Bastard Posted December 15, 2012 Report Share Posted December 15, 2012 I may get a hold of you after the holidays if you still have some stuff. Link to comment Share on other sites More sharing options...
Recommended Posts