John Posted January 12, 2010 Report Share Posted January 12, 2010 take liners outwashdryreinstall liners Quote Link to comment Share on other sites More sharing options...
BornSinner Posted January 12, 2010 Author Report Share Posted January 12, 2010 With the Shoei RF-1000 the liners dont come out without remove them from the glue.....So I went with the hand washing it in the bath tub....It work great....I let it dry over the heater vent all night, and it was dry in the morning.Good luck to all.... Quote Link to comment Share on other sites More sharing options...
SWing'R Posted January 12, 2010 Report Share Posted January 12, 2010 Febreze Quote Link to comment Share on other sites More sharing options...
AOW Posted January 12, 2010 Report Share Posted January 12, 2010 febreeze does kill the funk, but it is only a temporary solution and does not remove the biological oils that deteriorate the liners and padding. Quote Link to comment Share on other sites More sharing options...
Gump Posted January 13, 2010 Report Share Posted January 13, 2010 i pee in mineA little O this will do the trick:http://www.nilodor.com/shop/show/category/Commercial_%2526_Janitorial/department/Bio-Enzymatic/id/62Bio-Enzymatic Urine Digester This biodegradable, four strain bacteria formulation will provide immediate relief by neutralizing and eliminating the source of the odor. Extremely efficient at breaking down and digesting organic waste. The ORIGINAL fragrance has been approved by the Carpet and Rug Institute (CRI).Applications: Restrooms, Urinals, Trash Containers, helmets Quote Link to comment Share on other sites More sharing options...
flounder Posted January 13, 2010 Report Share Posted January 13, 2010 If my helmet liner doesnt come out, I do the same thing I do with my dirt bike helmet which is put liquid soap in in and spray it with the garden hose until it fills. Wash with hand and spray out and let dry.. its just plastic and Styrofoam so you wont hurt anything.HAHA.. I just went back and read that link.. I guess I was doing it right.. Quote Link to comment Share on other sites More sharing options...
BornSinner Posted January 13, 2010 Author Report Share Posted January 13, 2010 If my helmet liner doesnt come out, I do the same thing I do with my dirt bike helmet which is put liquid soap in in and spray it with the garden hose until it fills. Wash with hand and spray out and let dry.. its just plastic and Styrofoam so you wont hurt anything.That is about what I did in the tub....and it worked great....After it was dry....installed the speakers back in...and then the check pads....So Fresh...So Clean Quote Link to comment Share on other sites More sharing options...
Funjunkie Posted January 14, 2010 Report Share Posted January 14, 2010 Throw the lining in the washer, and let it shelf dry. It can handle it. Quote Link to comment Share on other sites More sharing options...
Gump Posted January 17, 2010 Report Share Posted January 17, 2010 just wasj it!!!!! Quote Link to comment Share on other sites More sharing options...
creep Posted January 17, 2010 Report Share Posted January 17, 2010 Honda makes a "helmet fresh" spray. I hear it works well, although I haven't tried it myself. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.