Jump to content

Nighthawk 650 issues, anyone?


Beegreenstrings

Recommended Posts

I have a 1984 Hond Nighthawk 650. CB650SC.

It was my dad's only new bike he ever purchased. He rode that thing all the time. I think it was his only get away from working his ass off most of his life to be sure I and my brother and sisters got what they needed.

He gave it to me a few years back, wanted to take it to Cycles-R-Us in Medina and drop it off, and I would not let him! It's been in my garage for a few years now and I have tinkered with it from time to time. But, I have no knowledge of this thing!

He stopped riding it when it died on him at my uncles house. Would not refire. I put the jumper cables to it and it fired right up. However, it will not stay running and has a miss.

I have replaced the rectifier and the stator (with the new upgraded design) supposed to be a better one for that bike)and a coil pack. Still same issues .

DOES anyone have knowledge of these issues with these bikes? I would love to make it streetable again. Truthfully I would love to return it to him so he could ride it again... Any help would be much appreciated.

Link to comment
Share on other sites

Well, I have one of those in pieces scattered all over...

Sounds like the battery is shot.

Determine if all plugs are firing properly. If not, find and fix.

My first guess is the carburetors. They have to need cleaning by now.

Replacing the stator was ok, they were known to die just from old age.

Link to comment
Share on other sites

If I were a betting man, I'd say carbs.

Run some Seafoam through it and see if that makes a difference.

I second that. I had an '85 nighthawk, when I bought it it ran fine. Then it started shutting off at random times. I had the stator replaced, and the carbs cleaned and balanced and it ran like new. They are actually really fun bikes to mess around on. I miss mine at times...although I looked like a Shriner riding it.

Link to comment
Share on other sites

If its been sitting for any amount of time with fuel in the carbs, They need to be pulled apart and cleaned. Every jet needs to come out and be cleaned. The emulsion tubes (the part that the needle jet goes through), has tiny little holes that block very easily. The idle jets also have tiny passages that will clog. Simply spraying carb cleaner down the throats wont do.

Get yourself a shop manual, a can of berrymans carb cleaner and have at it!

Another thing to verify is that you have a steady, strong spark. The early electronic ignitions honda used were garbage. I actually prefer breaker points to them. 1-4 fire at the same time, and 2-3 fire at once. It's a wasted spark system, so it fires on the power and exhaust stroke. The CDI boxes fail regularly on those. If you don't have spark on two of the cylinders, you can swap the cdi boxes and see if it changes where it is missing. The battery must be fully charged in order for the units to work well. I usually take out the bikes battery and wire it to a car battery while i'm trouble shooting.

PM me if you need anymore guidance. I've brought back 6 old hondas from the dead so far.

Link to comment
Share on other sites

Usually if it runs on choke, but wont run without it, It needs the carbs cleaned.

Another thing to verify is that the vacuum operated fuel shutoff is working. On my 82 nighthawk, and my friends 81 CB900F there was a small diaphragm on top of the carbs with 3 hoses going to it. Fuel in, Fuel out, and a vacuum line. It has to be pulling a vacuum on that line for fuel to flow. A cracked vacuum line would stop all fuel flow. Its also a common place for fuel to varnish as well, which would block fuel flow to the carbs. If you find that is bad, You can cap the vacuum line and run a fuel line straight to the carbs from the tank. We did that on the 900F, which also allowed enough room to install an inline fuel filter. Bypassing the shut off you run the risk of your whole tank draining onto the ground or into your engine if you leave the petcock on, but if your floats and needles are working properly you don't need to worry. That CB900F's shutoff was NLA, so that was the main reason for the bypass. You'll also find that it starts faster without it, since you don't have to be cranking the engine to start the fuel flow.

Edited by mgbgt89
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...