Browning

probably will, wish I was a little closer to it.(about an hour) clostest yard wants $45

Speedo went out and need a replacement cluster as soon as possible.

sorry for the bump. It's got to be in the cluster. Took it for a ride and it was working fine, then dropped to zero. smack the dash pretty hard and it starts working again. I found a site that says to redo the solder on the back but I'm not sure that's the problem. Anyways, the top of the dash needs removed. Does it all just pull off or is there a screw or two hiding somewhere?

alright. I'll call the local yard tomorrow and get it all as one. thanks

ok I'll pull that out and inspect the gears. Are we assuming the gears will be broke/worn or the sensor is just bad? Either way I think it's all one unit.

the sensor down on the transmission where the gear is?

any idea if they're easy to remove in these?

130,000 or so iirc

just started. Yesterday it started jumping, then stopped working at all. today it's just reading way off. Going slow(15 or so) and it's up around 50 lol I know there's a problems with the solder joints on the cluster but how do I determine whether this is a cluster problem or the gear in the transmission?

I like emftp and emeditor. As for help, check out http://www.w3schools.com/

Ohms is resistance. The lower the number, the less resistance there is on the circuit. A 2 ohm sub requires less power from the amp to run it than a 4 ohm sub

golfing sucks

nice. Not sure I could handle one that big though lol

20.1 widescreen. Needs to be bigger. Video card is just a 64mb that is built into this turd of a computer

send me some pics please?. very interested

have them powder coated

really just need a battery and charger but I'll buy the whole car if it's cheap enough. Got an old corvette tonight that I'm going to fix up/paint for my niece. It's a 6volt I believe but I think I can put something bigger in it.

needs bigger pics

bump. Cooking on the stove is getting old

I think it's 5/8

This is it. It's 54 1/4" wide, 14 1/2" tall, bottom is 8", top is 4" http://i41.tinypic.com/33n9imc.jpg Everything will work except the width. It needs to be under 52" wide to fit my s10. If I could get 2" cut off each end it would work.

I didn't know about them. edit-contacting the one in newark now.

I ordered a 12" wedge box from ebay and they sent the wrong one. Emailed them, and they refunded me, said they were out until the 15th and told me to throw it away. It's a nice box but it's too long. I'd like to find some where/one who could cut 2-3" off of each end, reseal it but do a great job while doing so. I could hack it up myself. Know of any places that can do this stuff?

oil is fine, it doesn't smoke, doesn't seem to be leaking coolant. I don't think it's a head gasket

any way to determine if the water pump is good by chance?