Jump to content

Columbus V.S Clevland.....


Evolved8

Recommended Posts

  • Replies 124
  • Created
  • Last Reply

Top Posters In This Topic

I dont need spray to get to 20 pounds, I just gotta turn the boost controller up. First I need to see why its runnin so shitty right now. I think the plugs might be gonzo.

 

Think you read it wrong. I think he means add the n2o back on OR up the boost. Not using n2o to up your boost.

 

Not sure though.

Link to comment
Share on other sites

http://i140.photobucket.com/albums/r2/ahmedsaleh101/1st%2093%20notch/untitled.jpg

http://i140.photobucket.com/albums/r2/ahmedsaleh101/1st%2093%20notch/a.jpg

http://i140.photobucket.com/albums/r2/ahmedsaleh101/1st%2093%20notch/q.jpg

 

lasted 1 2nd gear pull after 18psi setup installed. literally 5 mins after installin everything babied it to the highway and blew up gettin on the throttle on the onramp.

Link to comment
Share on other sites

If I remember correctly, they won't run with a crack like those above. One of my friends cracked two or three before he finally went with a Boss block and I think it just shut off and didn't restart when it went.

 

wouldn't very low vacuum and oil in the coolant/coolant in the oil also be a sign?

Link to comment
Share on other sites

Well, mine is running fine, no smoke or any noises. Has good oil pressure and doesnt over heat or anything. Its running like something is out of balance as in the flywheel or something.

 

Sounds like you should be looking at the balancer, and looking through the inseption cover at the converter and flexplate, making sure everything is tight in there as well.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...