RedLudeSH Posted September 13, 2014 Report Share Posted September 13, 2014 Any recommendations? Thanks! Quote Link to comment Share on other sites More sharing options...
Not Brian Posted September 13, 2014 Report Share Posted September 13, 2014 I don't have an answer, and I'm drunk in Kentucky at the moment, but I just wanted to say you haven't posted in years and hi! Quote Link to comment Share on other sites More sharing options...
STEVE-O Posted September 13, 2014 Report Share Posted September 13, 2014 Most won't, drilled you can do wihout any problem, however slotted doesn't go through the rotor so when you cut them you could cut the slot completely out depending how deep it is and the min spec obviously. Quote Link to comment Share on other sites More sharing options...
Cordell Posted September 13, 2014 Report Share Posted September 13, 2014 Most people are afraid the lathe with break it's bits off trying to cut them, they can be turned a little bit at a time but it takes forever. Good luck finding someone. Quote Link to comment Share on other sites More sharing options...
Patterson Posted September 13, 2014 Report Share Posted September 13, 2014 A shop with a Bridgeport mill has the ability, but wether or not they would is a whole different story. Quote Link to comment Share on other sites More sharing options...
RedLudeSH Posted September 13, 2014 Author Report Share Posted September 13, 2014 Hey there Not Brian! I've always read they can't be turned for reasons stated above so I've never bothered to ask. I posted about it on Trackhq and was told by people on there they get their slotted rotors turned all the time. Figured maybe I was just misinformed. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.